cell phone jammer itself can be maintained better | jammer phone cell

More commonly used GE LEXAN EXL1414, and Samsung HF1023IM. Need to pay attention to the application of the material, the following two points: avoid blindly reduce the intensity of risk, what parts of PC material molding difficulties and increased costs; not fully grasp on the strength of the case, the mold assessment Tooling Review, should be clearly told the mold suppliers may use the PC + ABS production of T1 products, but does not rule when the strength is not enough follow-up would be diverted to the possibility of the PC material. Such mold vendors to consider in the design of the mold good shrinkage and special parts of the draft angle. Usually the shell from the previous, under the shell composition, in theory, the upper and lower shell shape can overlap. The disassembly inspection process of cell phone jammer should be done very carefully.
But in fact due to the impact of the manufacture of precision mold, injection molding parameters and other factors, resulting in the next appearance of the size of the inconsistency, namely, surface scraping (the shell surface is greater than the bottom shell), or scraping the bottom (bottom shell is greater than the surface shell). The acceptable face scraping <0.15mm, acceptable to the end of scraping <0.1mm. Zero, deviation can not be guaranteed, as far as possible so that the surface shell is greater than the bottom shell. In general, the surface of the shell more button hole, forming shrink large, so the shrinkage large, the general election to 0.5%. The bottom shell molding has shrunk smaller, so shrinkage choose smaller, the general election by 0.4%, 0.1% of the surface shell shrinkage generally than the bottom shell. Even the two shell selection of the same material, but also reminded when making mold, the mold factory, after the shell to take a smaller shrinkage.  cell phone jammer  can be washed by the dedicated washing solvent.
Mold manufacturing of digital cameras, ABS + PC material is mainly based on the development of mold products. Mobile phone silicone mold. Phone silicone mold making process is as follows; preparation → rubber suppress → painting → punching → laser engraving → finished product packaging. Preparation: in fact, to create the original rubber and some of the ingredients (mainly toner and other dispensers) cooperate fully absorbed, and then extruded into the plate, then cut into strips of rubber needed for after the suppression of the rubber to suppress: the main process, it is accident prone, rubber parts, thin or very narrow, it may tear when removed (may be due to the rubber wall is too thin, too narrow, when mold temperature is high, about 100 ° C, the pieces of rubber is too soft, strong enough). After the complete washing of parts and components of cell phone jammer  is done.
Fan is an instance of class, see the 2024 buzzer outer edge seals; also flash (subsequent procedure stamping is not rushed), like the forming of this flash is really stubborn. Painting: painting to pay special attention to, believe the high scrap rate, generally to spray two paint is a different color for the back of the laser engraving. Good to spray finished, come back after the process. Stamping: Do not fly and shoots cut off, leaving the desired key, this process can not be rubber can not flash; often in small rounded a flash, not less than 0.5mm. Laser engraving: is the laser engraving is to do a good job in the key of flat, generally have a system with positioning, and then the laser key above the layer of lacquer carving out, bring up the key words above, such as a digital key, that is transparent . The visual inspection of   cellphone jammer can check parts and components.